The output voltage is continuously adjustable on OUT+ and OUT- screw terminals (Output voltage must be greater than input voltage).Easy to drive 65W 90W dual-core notebook.Onboard LED illuminates when the voltage is applied to the module.The non-isolated step-up power conversion module.Input Current: 16A (MAX) (Please enhance heat dissipation if more than 10A).For high loads this might not be an option so be cautious of the input polarity or you might fry the module! Please note there is no reverse polarity protection. It is especially useful for automotive 12V applications, where standard 12V battery power can be boosted to 19V for use as a laptop computer power supply, or to 18V or 24V for other applications requiring higher voltages.
This 150W DC-DC Boost Converter 10-32V to 12-35V 6A Step-Up Adjustable Power Supply is well into the heavy-duty end of the spectrum 150W as you can tell by the huge toroidal inductor and dual heatsinks. Note: all data are taking the highest rarity Weapons of that types for example, for complete information, click on Weapons Type to link to pages introducing them.This versatile DC-DC boost power supply/converter module steps up any input voltage from 10V to 32V to any output voltage from 12V to 35V at up to 150W output power and 6A current. This is a good technique for continuously dealing damage with lasers and slowly regenerating energy at the same time (this is only true for the less power consuming lasers, wasps and hornets) or until you find cover. A common strategy is a laser/plasma combo, dishing out area damage with plasma cannons in quick succession (maxing out fire rate), depleting your energy, and then deal less but steadier damage with lasers. Strategy-wise, it is important to manage your energy well.
#Power booster robocraft full#
For example, Lasers seem to consume minimal power at the cost of having less DPS, while plasmas will consume a full energy reserve in several seconds for high DPS in firing continuously. Each weapon consumes power at different rates. Power consumption is a method for limiting burst damage of some bots while allowing for weapon variation and redundancy. "The amount of weapon energy available to players will be 12,550 (the same amount for a 1,600 CPU Robot)" - Robocraft official website.
#Power booster robocraft update#
Then this is altered in the DAMAGE BOOST & CRF 2.0 update on to prevent the conflict with Damage Boost system. The Power bar will always take 10 seconds to recharge from empty to full, but since the maximum Power depends on CPU, this effectively means Power regenerates 25% faster at 1750 CPU and 25% slower at 500 CPU." - Robocraft official website. "1750 CPU robots will see an increase of 25% power and power regeneration and 500 CPU robots will see a decrease of 25% power and power regeneration. When the Aeroflak Sentinel & Power Update was launched, the power of a robot depended on the CPU. Īfter that, with the From Passive Power to Active Energy change on, usage of the Weapon Energy Module had been altered from boosting the power regeneration speed passively to restoring a fixed amount of power instantly when activated, which also means it occupies a loadout slot currently. The time costs a robot to fully regenerate its power is fixed to 10 seconds through the Balance and CPU Changes, which attached to the Aeroflak Sentinel & Power Update on. Power constantly regenerates, unless you're firing any weapons or your Ghost Module is actived. , its de-active sound will replace all these(blink red and sound a warning). If you press the load out key of Ghost Module, the power displaying bar will do so too, but for Ghost Module, if you just keep cloak until power runs out completely If power is used up or not enough power is available to use the currently activated weapons, it will blink red and sound a warning until enough power is restored. A robot's current power amount is displayed by two blue bars at the sides of crosshair, all weapons and the Ghost Module draw a certain amount of power upon use.
0 kommentar(er)
